Resources
Home-Application - Aerospace & Military -Vacuum Oven

Vacuum Oven

Vacuum ovens are used for drying sensitive substances that may be damaged by excessive heat, and for applications that require extremely low residual moisture levels.
Model MT-3020S MT-3050S MT-3090S
Workspace Volume(L) 25L 58L 90L
Workspace Dimensions(mm) Width 300 415 440
Deep 300 350 425
Height 280 400 485
External Dimensions(mm) Width 635 750 780
Deep 465 515 600
Height 450 570 620
Net Weight(kg) 43 65.5 105.5
Performance Temperature range 50℃ to 200℃
Vacuum degree <133 pa
Construction Material Exterior Cold-roll steel sheets with static powder coating spraying
Interior Stainless steel
Specimen holder Aluminium plate
Thermal insulation Insulated cotton
Viewing window Double-layer explosion-proof and tempered glasses
Sealing Silicone rubber door seal
Vacumm system Deflation valve on the panel and vacuum port in the back
Heating way Every aluminum plates makes effective contact with the heater element, finally to make the test specimen get the most optimized heat transmission. Every aluminlum plate could set temperature different(Total 3 levels.)
Control system Controller Digital display temperature controller
Temperature sensor PT-100Ω Dry bulb
Timing range 0~999 min
Control accuracy ± 1 ℃
Facility requriement Electricity supply 220V 50/60HZ 1 phase
Operating environment conditions" +5℃~ +28℃ ≤ 85%RH
Accessories Specimen holder
Safety protection Over temperature protection;
Explosion proof protection
Description

Vacuum ovens are used for drying sensitive substances that may be damaged by excessive heat, and for applications that require extremely low residual moisture levels. It also can rush into inert gas to the internal, especially of some compound material can also be quickly drying.

Vacuum dry oven is suitable for the universities and colleges, scientific research, factories and mines, under the condition of vacuum to drying, heat treatment. Reduces the drying temperature, avoid some items heating oxidation, clean grain of destruction.


Standard Features
Interior stainless steel plate (sus#304)
Exterior cold-roll steel sheets with static powder coating spraying
3 levels shelves, aluminum plates
Every aluminum plate makes effective contact with the heater element, finally to make the test specimen get the most optimized heat transmission. Every aluminum plate could set different temperature (Total 3 levels) so that different test specimen could get different temperature requirement
High quality fiberglass insulation
Welded structural base frame with removable service panels
Dual silicone one-piece door gaskets with vulcanized corners to maintain high vacuum degree inside the chamber
Tempering double layer anti-explosion glass door
High precision PT100 temperature sensor
Digital display temperature controller
Over temperature alarm and timing function
Microcomputer PID control technology
Every vacuum oven must make 24 hours air leakage test

Optional Accessories
LCD display temperature controller
Interior material galvanized sheet for saving cost
Additional temperature protection for test specimen
Vacuum pump

Note:
This model is used for routine experiments and tests, and cost effective. It supplied for Health, Medicine, Biology, Agriculture, Research etc. relative institution and department to make powder drying, sterilization and disinfection of different glass container, heat treatment and heating, but not suitable for volatile, flammable and explosive products.

Call me!